Transformer toy from colored paper

Toy transformer
In order to make such a toy you will need 12 sheets of colored paper. Three colors of 4 sheets. The sample used blue, red and yellow colors.  Toy transformer
The paper size should be 14x14 cm. Therefore, from one sheet of A4 colored paper you can make two squares. It is advisable to take a thick paper, but not cardboard. In order to clearly see the folds, purple paper is used in the sample module. Fold underlined handle. If you collect such a module on a product, you do not need to emphasize the handle. You should take a sheet and bend it in half so that a triangle is formed from the square, as shown here.
 Toy Transformer
We got a diagonal of a square.
 Toy transformer
The same actions are made on the other hand,to make the curves look like here.
 Toy transformer
Next, the square is bent in half.
Transformer toy Bend the halves once more in half, from one side and the other.  Toy Transformer
 Toy Transformer We are rolling back. Again, bend the sheet by 1 cm from both sides.
 Transformer toy
 Toy transformer
As a result we get such folds on the sheet.
Transformer toy
Again, select the diagonal folds.
Toy Transformer
We take the transverse fold line and join them together to make a triangle.
 Toy Transformer
Toy transformer
Smooth it well so that the sheet does not bristle.
Toy transformer
Then put one finger on line by In the middle of the triangle, with the other finger, its lower part is taken and rises up to the sharp corner.
 Transformer toy
 Toy Transformer
The edges of the paper that crumble , smoothing down.
Toy transformer
 Toy Transformer
This same action is performed on the back of the triangle . It turns out a cute little house. Toy transformer
 Transformer toy
Then you can see that the house has a bend line below.On this line, bend the outside of the paper, but not completely.
 Toy Transformer
The rest of the side is bent in the shape of a triangle.
 Toy Transformer
The same actions are made on the other side of the house. In total, they should be four. Two on one side and two on the other.  Toy transformer Unbend everything back as it was.
 Toy Transformer

This is what happened.  Toy transformer The same modules are made from the remaining 11 sheets.
 Toy Transformer
After the modules are done, you can proceed assembly.
Toy transformer
One of the two triangles of the module must be pushed into the "pocket" of the other.
 Toy Transformer
 Transformer toy
And so all 12 modules.
 Transformer toy
 Toy Transformer
Turn the connected modules upside down.br>
 toy transformer
Take the connection between the two colors (there is a noticeable fold line), fold it inwards.
 Toy Transformer
Toy Transformer
We are working through the inner bending well.
Toy Transformer
 Transformer toy
This is done with each connected sheet on both sides.
Transformer toy
After all the corners are bent inward, we begin to work through the sides of the product. The first and last module does not touch. On the model product, the extreme module is red, it is connected to blue.This side we leave. Then the place where the blue module connects to the yellow one starts with them.  Toy transformer We unfold them as a book, thus:
Transformer toy
The transverse fold is visible from above. We are bending him.
 toy transformer
This is what should be the result:
Transformer toy

Next, turn as a sheet of the book to the next module. And we do the same actions, and almost until the last module (we don’t touch it).
 Transformer toy
Transformer toy
 toy transformer