A hairpin made of satin ribbons
Such a bouquet of roses will be an excellent decoration for the hair.
For a bouquet of roses we need the following materials: - ribbon pink, 2.5 cm in width and 230 cm long. -lench of white color, 2.5 cm in width and 154 cm in length. - satin ribbon of green color with a length of 150 cm. pistol for decoration: a few beads, fishing line, braid. - flower stamens. - lighter. - hair clip big for hair. thread. - scissors. Getting started with tape cutting. We take a ribbon of pink hue and cut into strips 7 cm long. One flower will need 11 strips, and pink roses will have three, respectively 33 strips, in total.
We start with one rose. We take 11 strips and begin to make them flower petals. The edges are burned with a lighter. In each strip on the wrong side we bend the corners on both sides and fixsewing needles.
Now take the needle with threads, preferably in the color of the ribbon, and fix it around the edge where the needles were bent.
Then draw a string and fix the resulting petal.
Then we will collect a bud with a glue gun. It consists of 3 petals. The first workpiece is twisted by a tube and fixed. Now glue it to the middle of the second petal along the entire height, pressing the edges.
And the third petal is glued, closing the free edges of the second . The bud is ready.
The second row also consists of 3 petals.We glue these blanks a bit with each other, placing them in a circle.
But in the third row there will be 5 petals, also with overlapping spirals. The flower is ready.
And finally three pink and two white roses are obtained.
Now you need to glue substrates to the colors. They are green, so we will cut out of green satin ribbons. Cut into strips with a length of 6 cm, 25 pieces. 5 pieces per rose.
Take a strip in half lengthwise, facing inward, and searing with scissors, gluing the edges to each other or cutting a soldering iron with a fine tip.
We turn these 5 petals upside down, we get the form boats.
But on one side of the leaves cut off the corners from 0.5 to 1 cm,flat edge we burn.
When the leaves are ready, turn the rose upside down and glue these blanks to the middle of the bottom of the rose.
A rose with green leaves is ready.
In the same way we glue leaflets to all 5 roses.
Now we need a base on which we will collect our bouquet. Cut 2 circles in diameter 7 cm.
And for decoration we take a braid 40 cm and any thin fishing line 60 cm long.
For one circle we glue the braid, and with the second circle we cover, fasten with a glue gun.
We cut the thin ribbon into three strips and fold each 2 times in half,fixing it with a needle.
Straighten, it turns out 2 curls.
Now take the stamens and paste them between these two blanks. And on the line we glue small beads with an interval from each other.
We now proceed to the assembly of a bouquet. Between two white roses we glue a curl of beads.
And then we attach them to the finished base, gluing with a gun. They will be located slightly receding from the middle, closer to the edge.
Now roses are pink, we have a number,based on.
To decorate a bouquet between roses you need to fix the stamens with curls.
It remains only to fix a large hair clip on the base with roses. Well, here's the hair ornament is ready.