How to make pots?

Watch the video

How to make pots?

Pots can be made from anything. In this article we will look at two options: how to make a flowerpots with your own hands for the house and for the garden plot.

How to make a pots in the room

Consider how to make hanging woven pots for indoor plants.

Preparation for the process

To work you need to prepare:

  • scissors;
  • gum (can be stationery or those used for hair);
  • thread (40 m);
  • needles;
  • a cushion for fastening threads on it (it will serve as a workplace);Cache-pot
  • a ring with a diameter of 4.5 cm (eyelets from curtains or rings from key fobs are suitable).

Step 1

Cut the threads to 5 meters in length in the amount of 8 pieces. We fold not in half, but so that one edge is 1.5 m and the other is 3.5 m. We put the thread folded in this way under the loop with the loop at the top, bend it onto the ring, after which we thread both ends of the thread into the loop and tighten it.

Step 2

With the next thread doing the same thing. Only now we change the location of the ends of the threads. The first is the one that 3.5 m, the second - 1.5 m. We tie the thread, each timeCache-potalternating them in that order.Then the ring is attached to the pad with needles.

So that the threads are not confused among themselves, you can fasten the inner short (1.5 m) ends of one rubber band, the outer long ones (3.5 m) - with the other.

Step 3

Perform weaving directly. The working 3.5-meter yarns are used, the 1.5-meter knotted threads are consumed little. The 1st working thread is bent at an angle of 90aboutand is superimposed on top of two nodules, the 4th thread (working) is placed on top of the first one and winded up under two nodules. Then (on top of the 1st one) it is pulled out of the loop formed between the first three threads and pulled into the knot. Similar weaving techniques are performed by pots of the pots, bartack, jumper and the basket itself.

How to make flowerpots in the garden

We give the manufacturing technology of pots in the form of a swan.

Preparation for the process

To work you need to prepare:

  • 5-liter square-shaped plastic bottle;
  • putty;
  • bandage;
  • water;
  • sand;
  • iron bar;Cache-pot
  • putty knife;
  • tassel;
  • metal mesh 15x30;
  • dishes for the solution.

Step 1

Remove one side of the plastic bottle, set on a table covered with plastic wrap. In the cork closing the neck, we make a hole and insert a rod bent in the shape of a swan neck.Fix it with tile adhesive. Inside the bottle pour some sand, while expanding its edges.

Step 2

From the putty we make a thick solution and lay it on the polyethylene by the size of our bottle, it will be the bottom of the cache. Put the bottle on top and put a solution with a spatulapotson its edges, making a layer of 2 cm.

Step 3

At this stage we make wings and a neck for our swan. The wings will be two pieces of the grid 15x30, which we press into the sides of the figure. After that we cover them with mortar and make them relief, applying strokes in the shape of feathers. The rod, which serves as a swan's neck, is also covered with a putty solution and wrapped in a circle with a wet bandage. Making a head. Top again covered with a thin layer of putty.